Cart
The Billet fender brace for the S14 was developed after years of drifting with an S-Chassis. During our testing, we noticed extensive flex in the front strut towers under heavy load, largely due to drivers cutting out the front portion of the wheel well, and not properly reinforcing the strut tower to compensate. In some cases, just a strut bar will give you the desired integrity but this still leaves the "paper mache" section between the strut tower and firewall. This section of the car is made up of 18-20g sheet metal, with some spot welds holding everything together. So to strengthen this area of the chassis, we developed a simple bolt-on solution that will brace and stiffen up the front of your S-chassis.
The braces are for both Left and Right side, they will include all mounting hardware.
Note: The back of the brace bolts to the factory holes used for fastening the door to the chassis. The front of the brace has 3 predrilled holes that you will use as "transfer holes". To install the front portion of the brace, you will need to weld on the provided brace plate to your upper fender, drill, and then thread the holes to fasten the front portion. "Using the pre-drilled holes as your reference" is the strongest and most effective way to fasten the brace in significantly improve the chassis' rigidity.